[ Chinese wardrobe network ] With the continuous improvement of the living standards of modern people, the overall concept of home has been continuously infiltrated, and people's understanding of decoration has also reached a further level. As a personal privacy space, it is extremely necessary to install a whole wardrobe . The following Chinese wardrobe net will introduce you to the precautions for the overall wardrobe installation.
Small bedroom overall wardrobe installation precautions one
Use a cloth to place the floor, first assemble from the wide side panel against the end of the wall, and lay the wide side panel on the ground (maintain 700mm away from the rear wall). First, put the plate of the filled three-in-one rubber plug on the cloth, check the hole spacing and the drawing, and install the three-in-one single-link. Then the solid layer is nailed to the cork, fixed on the wide side plate, the top handle with the large handle hole facing upward, the other solid layers are facing downward, and the foot line large handle hole is facing inward (the middle solid layer is consistent with the L frame height, that is, the bottom plate to the solid layer The inner space is 960mm, and the hole is drilled on site.) Put the side panels, nail the cork, and the cork is required to connect the solid layers on both sides. Install the double connecting rod on the second cabinet. Note that the large handle on the double connecting rod can only lock half, that is, 90°. When the two solid layers are fixed to the side plates, tighten the large handles at the same time. Repeat the installation steps for the second cabinet when installing the third cabinet.
Small bedroom overall wardrobe installation notes II
Nail back plate. Place the assembled whole cabinet on the floor of the point cloth, and lay the side panels in the same plane. Use a slider to measure the diagonal size of the cabinet and adjust it to the same level. Start with the first backing plate from the wide measuring board. Note that if there is a solid nail in the middle, draw the center line of the solid layer with a pencil and nail it. nail.
Small bedroom overall wardrobe installation notes three
Installation of the L frame. Use the side plates of the L frame to have a parallel line on the corresponding side plates, then move the center line of the three-in-one rubber particles up by 9 mm, and draw a parallel line on the corresponding bottom plate with the top frame of the L frame. The inner center 9mm draws the center line of three rubber pieces. The hole was drilled with a 10 mm drill bit and the hole depth was 10-20 mm. Install a single pole. After the L frame is installed, nails are fixed on the back plate.
Small bedroom overall wardrobe installation notes four
Clean up the wardrobe installation debris, one person at the left and right, the wardrobe is slightly inclined backwards, lifted hard, and moved back to the desired position. Be careful not to scratch the floor or the wall.
Small bedroom overall wardrobe installation notes five
1) The three-in-one rubber pellet is as in a 1 drawer hole;
2) connecting the 2, 3 side plates to the pumping surface;
3) Connect 4 and 2, 3 side plates and plywood with intermediate solid layer 3.5*40 screws;
4) Insert the back plate 5 into the slots 2 and 3, and fix it on the rear plate 4 with small nails, and install the in-line handle (the drawer requires squareness and maintain the angle of 90°).
Lash Tape,Eyelash Tape,Eye Lift Tape,Tape For Eye Lift,Lash Extension Tape,Tape For Lash Extension,Eyelash Extension Tape,Eye Makeup Tape
Shenzhen Nanfang Shishang Cosmetic Utensil Co., Ltd. , https://www.nfbrush.com