Toilets are common and everyone is familiar with them. It is an indispensable equipment in our bathroom, but many consumers do not understand the installation of flush toilets, so it is easy to lay hidden dangers for future use. Below and Xiao Bian to learn more about the toilet parts purchase and installation skills.
What do we need to pay attention to when purchasing accessories?
1, the amount of water: should choose the right amount of water storage toilets, high water storage will splash butt, water storage capacity is too low to run the taste.
2, glazed: good quality toilet glazed surface should be smooth and smooth without foaming, color saturation. After inspecting the glazed surface, you should also touch the sewer of the toilet. If it is rough, it can easily be left behind.
3, Installation: After the toilet is installed, try the flushing effect in the first time. The best way is to find a cigarette butt and throw it in, you can rush it down, and the sound is not big, indicating that the installation process is no problem.
4, hole distance: Each house has a different toilet installation hole distance, before buying a toilet, we must allow workers to help you measure well, otherwise it is likely to buy the toilet can not be installed.
After the introduction of the selection of accessories, the following Xiaobian to take everyone to see the toilet installation method:
1. Before the toilet is installed, check whether there is any sediment, debris, etc. inside the sewage pipeline, and whether the installation floor is horizontal. Toilet sewer pipes should adopt national standards. The inner wall of the plastic pipe should be smooth, flat, free of bubbles, crack-free buckle, no obvious marks and depressions. In particular, it must be ensured that the sewage pipe is about 10mm above the ground.
2. Determine the center of the sewage pipe and draw a cross centerline.
3. Determine the center of the toilet flush outlet and draw a cross centerline.
4. Determine the installation position of the bottom of the toilet. Use a drill to drill the mounting holes and embed the expansion screws.
5. Install a special sealing ring (steaming wax flange or rubber flange) on the sewage outlet of the toilet or place a circle of glass glue (putty) or cement slurry around the drainage pipe. The ratio of cement to sand is 1:3.
6. Align the reticle on the toilet with the crosshair on the ground, install the toilet, and then place a circle of glass glue (putty) or cement mortar on the bottom of the toilet. The ratio of cement to sand is 1:3. Toilets should be installed horizontally.
7. Screw on the toilet mounting hole.
8, install and debug tank accessories. After installation, turn on the water source, check whether the water inlet valve and the sealing of the inlet valve are normal, check whether the drainage valve and the installation position correspond to each other, whether the installation is tight, whether there is leakage, check whether the length of the button switch chain is appropriate, whether the switch is flexible, whether Opportunity jams, check whether the inlet valve filter device is missing.
Accessories and installation tips for toilets are introduced here. The above is the accessories for toilets purchased and installed by Xiao Bian. We hope to be helpful to everyone.
<\p><\div>
Round Beach Towel,Microfiber Travel Beach Towel,Printed Microfiber Beach Towel,Travel Beach Towel
Jinan Huatian Leinuo Trade Corporation Ltd. , https://www.huatianleinuo.com