1. Check whether the ink printed on the machine is the type of ink required by the customer, so as not to cause a major printing error due to the wrong color.
2, when the machine on the first full ink mixing, ink storage for a long time there will be stratification, but will not affect the quality.
3, on the machine when the added ink is best about 10kG, so as not to cause excessive evaporation caused by ink, if 10G is not enough and then slowly appropriate to add to the printing press.
4. When blistering occurs during printing, appropriate water-based defoamers can be purchased from the ink supplier, and the proportion is generally 1%.
5, in the ink on the machine, the printing staff should pay attention to the viscosity of the ink and the machine on the machine viscosity, so as not to affect the printing effect.
6, the printing process, the quality inspection personnel should strictly control the color, the color deviation is very small, the printing press can adjust the viscosity of the printing press or ink solution. When the color deviation is large, the ink supplier of the ink supplier must be notified to make improvements.
7. When printing, the printing effect is not good, for example: the dot printing is not clear, the font printing is not clear, the overprint effect is not good, and the quality inspection should immediately notify the ink supplier to solve.
8. The viscosity of the ink on the machine must be controlled. Generally, the machine viscosity of each printing machine must be recorded so that the next printing can save time and reduce paper waste.
9. The carton factory should purchase some related auxiliaries from the ink and wash company, such as anti-wear agent (used to prevent discoloration), dilute agent (used to adjust the viscosity), superimposition agent (make the superimposition effect better), etc. Add to.
10. After the printing is finished, the remaining ink must be sealed and the trademark is properly attached to ensure the use of the next printing so as not to reduce waste.
2, when the machine on the first full ink mixing, ink storage for a long time there will be stratification, but will not affect the quality.
3, on the machine when the added ink is best about 10kG, so as not to cause excessive evaporation caused by ink, if 10G is not enough and then slowly appropriate to add to the printing press.
4. When blistering occurs during printing, appropriate water-based defoamers can be purchased from the ink supplier, and the proportion is generally 1%.
5, in the ink on the machine, the printing staff should pay attention to the viscosity of the ink and the machine on the machine viscosity, so as not to affect the printing effect.
6, the printing process, the quality inspection personnel should strictly control the color, the color deviation is very small, the printing press can adjust the viscosity of the printing press or ink solution. When the color deviation is large, the ink supplier of the ink supplier must be notified to make improvements.
7. When printing, the printing effect is not good, for example: the dot printing is not clear, the font printing is not clear, the overprint effect is not good, and the quality inspection should immediately notify the ink supplier to solve.
8. The viscosity of the ink on the machine must be controlled. Generally, the machine viscosity of each printing machine must be recorded so that the next printing can save time and reduce paper waste.
9. The carton factory should purchase some related auxiliaries from the ink and wash company, such as anti-wear agent (used to prevent discoloration), dilute agent (used to adjust the viscosity), superimposition agent (make the superimposition effect better), etc. Add to.
10. After the printing is finished, the remaining ink must be sealed and the trademark is properly attached to ensure the use of the next printing so as not to reduce waste.
Claw feet are accessories of freestanding cast iron bath tubs. Color of claw feet can be white, black, chrome, brushed nickel and oil rubbed bronze. Material of the feet is cast iron. The claw feet are in many different shapes and sizes.
We supply faucet of Cast Iron Sink.
Sink Faucet,Sink Faucet Bathroom,Utility Sink Faucet
Anping Sunshine Sanitary Ware Co., Ltd. , https://www.sunshinebathtub.com