High and low temperature test chamber can count positive and negative, generally can wind all kinds of motor coils within 1600KW, and is equipped with a set of simple tensioners. It can control the tightness of the wound coil. The general repair manufacturers can choose the above products, such as when encountering special large specifications. Special winding equipment can be selected. 2. Wrap the high-voltage motor shuttle coil before forming and wrap it with shrink tape, yellow wax tape and other insulating materials. The purpose is to protect the outer insulation, interlayer insulation and turn insulation of the coil from damage. It is free from friction from mold fixtures, pins at the nose of high and low temperature test chambers, etc. during the drawing machine. Because female workers are attentive and quick-working, generally 3-5 people are bandaged for pulling. Electric belt wrapping machine can also be used. 3. The forming machine, expanding machine and drawing machine are actually a kind of machine. Its main purpose is to pull the vertical winding shuttle coil or the flat winding shuttle coil wound by the winding machine. Framed coils, frame-shaped coils take the inner and outer circles of the stator core of the motor as the standard, and form a centripetal angled coil. Winding the shuttle-type coil requires 2 technicians to complete. ) Type generally requires 3 people. Before there was no molding machine.
72 coils can be drawn by hand in 15 minutes, but it is a bit difficult for larger coils. With the drawing machine, three people can pull out 72 coils within an hour, and the linear part of each forming coil can be adjusted up to 1.5 meters. The height can be adjusted within 80 cm. The angle adjustment range is 0-60 degrees. Four fixtures can achieve universal locking. General manufacturers of high and low temperature test chambers. An electric motor factory in Harbin, a subordinate factory of Xiangtan Electric Motor Factory and other more than ten companies purchased the manual drawing machine. The overall evaluation is that the production seems simple. But the operation is flexible and convenient. With the upper module, the mold is ejected quickly, the drawing is convenient, the positioning is accurate, and the angle adjustment is accurate. It is a practical product. Before drawing, use a computer to draw the shape of the coil according to the actual situation of the repaired motor and make it into a template for adjusting the drawing machine. Those who can not draw generally adjust the drawing machine with the old coil as a template. The four clamps of the drawing machine have up, down, left, and right adjustment mechanisms.
Crowding and embedding can not be placed when embedding, which makes it difficult to embed the wire, which requires cold shaping. Cold forming molds (or positive molds) are traditionally made of wood. Each type of motor needs to make a set of molds. The positive molds used by our company are equipped with pitch adjustment, angle adjustment, and end height adjustment. Flexibility. Care must be taken when striking during the positive type, not to damage the interlayer insulation. After pulling the low-voltage motor in the high and low temperature test chamber, it is generally no longer cold-integrated, and directly enters the wire embedding process. 5. After the mica bandage and the hot-pressed stator coil are cold-shaped, they enter the bandaging process. At present, the materials with high coil insulation are basically domestically produced, but the quality and price of mica materials are very different. Our company has been manufacturing coils and winding high-voltage motors for many years.
Pet Electronics Toys,Cat Electronics Toys,Electronics Toys
Ningbo XISXI E-commerce Co., Ltd , https://www.xisxipetsupplies.com